“The closed-vacuum-chamber design not only maximizes powder re-use but also prevents argon-gas bubbles from permeating the part. When parts produced using this technology undergo hot isostatic pressing, quality is comparable to forged parts. Such results are a must for aerospace parts that periodically need to withstand high amounts of pressure.”— Ronen Sharon, Sharon Tuvia on DMP Technology
Throughput and Repeatability
The DMP Flex 350 and DMP Flex 350 Dual are high throughput, high repeatability metal 3D printers that generate high quality parts in a broad range of alloys. These solutions integrate the printer, software, and advanced materials with expert application support.
High Quality, Dense Parts
Whether you choose the single-laser or dual-laser configuration, the high-performance metal additive manufacturing system is a heavy-duty alternative to traditional metal manufacturing processes: With a build volume of 275 x 275 x 420 mm (10.82 x 10.82 x 16.54 in) it offers reduced waste, greater speeds for production, short set up times and very dense metal parts with excellent mechanical properties.
About this printer
- Reduced weight/light-weight design
- Orthopedic and spinal implants
- Uses Direct Metal Printing (DMP) technology
- Build volume (W x D x H): 275 x 275 x 420 mm(10.82 x 10.82 x 16.54 in) –height inclusive of build plate
- Unique vacuum chamber concept
- Best in class oxygen purity (consistently below 25 ppm)
- Quick-swap build modules
- Fast bi-directional powder deposition
- Optional Build Volume Reducer for experimentation with small metal quantities
- Simplified assemblies
- Reduced number of parts
- Conformal cooling
- Enhanced fluid flow
- Conformal latticework
- Topology optimization
- Mass customization
Commonly Used Materials for the DMP Flex 350 Printer
LaserForm Ti Gr1 (A)
Light weight, biocompatible, extreme temperature and corrosion resistance
LaserForm Ti Gr5 (A)
High strength, low weight, excellent biocompatibility
LaserForm AlSi10Mg (A)
Good mechanical properties and good thermal conductivity
LaserForm AlSi7Mg0.6 (A)
Light weight, good mechanical properties and improved thermal conductivity
LaserForm Ni625 (A)
Excellent corrosion resistance, high strength and heat resistance
LaserForm Ni718 (A)
Oxidation, corrosion and extremely high-temperature resistant
LaserForm 17-4PH (A)
Excellent corrosion resistance, high strength with good toughness
LaserForm 316L (A)
Able to be sterilized and highly corrosion resistant.
LaserForm CoCrF75 (A)
Highly corrosion, wear and heat resistant. Bio-compatible.
LaserForm Maraging Steel (A)
Excellent hardness and strength, good wear resistance.
Certified Scalmalloy (A)
High strength aluminum with excellent corrosion resistance
Certified M789 (A)
Cobalt free, high strength tool steel with excellent corrosion resistance
Commonly Used Materials for the DMP Flex 350 Dual Printer
LaserForm Ti Gr1 (A)
Light weight, biocompatible, extreme temperature and corrosion resistance
LaserForm Ti Gr5 (A)
High strength, low weight, excellent biocompatibility
LaserForm Ti Gr23 (A)
High strength, low weight, excellent biocompatibility - lower Oxygen than Gr5
LaserForm AlSi10Mg (A)
Good mechanical properties and good thermal conductivity
Interested in purchasing this printer?
You Might Also Be Interested In
DMP Factory 500 Solution
Robust, high quality metal AM with integrated powder management
DMP Factory 350 and DMP Factory 350 Dual
Scalable, high quality metal AM with integrated powder management
DMP Flex 100
Affordable, precise metal 3D printer for finest features and thinnest walls