The D2P software is intended for use as a software interface and image segmentation system for the transfer of imaging information from a medical scanner such as a CT scanner to an output file.  It is also intended for pre-operative surgical planning.

The 3D printed models, generated from the D2P output file, when printed in conjunction with the materials and printers included in the table below and following the instructions included in the User Manual are validated for diagnostic use.

Please refer to the D2P User Manual for additional instructions on goof printer operation and post-processing instructions.

Other printers may be used with D2P.  However, the physical outputs from these printers have not been validated by 3D Systems and so are not cleared to be used as diagnostic quality models.

Technology Printer Model Material Medical Specialty Software Version
ProJet Printing (CJP) ProJet CJP 660Pro VisiJet PXL + ColoBond infiltrant Cardiovascular
Craniofacial
Gastrointestinal
Genitourinary
Musculoskeletal
Neurological
3DPrint v1.03.8
Stereolthography (SLA) ProJet 7000 HD Accura ClearVue Cardiovascular
Craniofacial
Gastrointestinal
Genitourinary
Musculoskeletal
Neurological
3D Sprint v2.9.1.1014

Printer Interface v1.6.2870.0
Multijet (MJP) ProJet MJP 5600 CR-WT-200 Cardiovascular
Craniofacial
Gastrointestinal
Genitourinary
Musculoskeletal
Neurological
3D Sprint v2.9.1.1014

Printer software v7.1.9663
CE-NT Cardiovascular
Gastrointestinal
Genitourinary
Neurological
Selective Layer Sintering (SLS) ProX SLS 6100 DuraForm ProX PA Cardiovascular
Craniofacial
Gastrointestinal
Genitourinary
Musculoskeletal
Neurological
Build Setup v6.1.7

Sinter Application v6.1.9